Multi tool saw holder9/21/2023 ![]() ![]() ![]() If you are looking for a good stud finder, the Franklin Sensor is the one I highly recommend. The first thing I did was use my stud finder to go along my wall and mark the location of all the studs. You can check out my original post from my first DIY power tool storage system here.I used 1 1/4″ screws to attach the cleats on the back, then 1 5/8″ screws for everything else on the holders Be sure to predrill all of the holes so you don’t split your wood.(For something as big as mine, I would buy a sheet of plywood). If you don’t have any scraps then I would recommend either buying one sheet of 3/4″ construction grade plywood, or buying a few 1x pine boards depending on how big your system will be. The first time I built holders I used some scrap 1x pine boards so just use whatever 3/4″ scrap you have laying around. ![]() I used 3/4″ scrap plywood for this entire build so I didn’t buy any material.Ok before I get going, a few things to Note: Here is a photo illustrating the French cleat. I went ahead and took photos of each holder and also listed out the dimensions that I used incase you are trying to do the same thing. I’ve been using the system for a year now to hold my power tools but since I just got new power tools I had to make new holders. This way you can set the holder on the cleat that’s on the wall and gravity takes over from there. One is attached to the wall, then the other is attached to the back of a holder. If you haven’t heard of a French cleat, it is a system made up of two cleats that are cut at a 45 degree angle. Check out this easy to follow DIY tutorial! Learn how to make a DIY Power Tool French Cleat System as a Drill Holder that will help you organize your power tools. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |